Is water coming out of a pipe or fitting right now?
Shut the main valve first. In most Guelph houses it is in the basement where the water line comes through the front wall, near the meter. Turn it clockwise until it stops. Then open the lowest cold tap in the house so the lines drain instead of pushing more water out of the leak. If water is near a light fitting, an outlet or the electrical panel, stay away from it, and only switch off a breaker if you can reach the panel from dry floor. Then call: a pipe that is spraying or running is an emergency plumber job.
In winter, a leak is usually a pipe on an outside wall or a line to an outdoor tap that froze and split. The City of Guelph notes that frost retreats slowly, usually from the top down, so a frozen pipe can stay frozen well after spring arrives and only show its crack when it finally thaws. Outside of winter, a drip at a joint is more often a worn fitting or a section of pipe corroded from the inside. A single failed fitting is a single repair, and the main valve stays off until it is done.
Could your water line be lead?
If your house is in St. George's Park, Exhibition Park, The Ward, or the Brooklyn and College Hill district, it may date from the 1850s to the early 1900s. Ontario houses of that age typically began with a lead or galvanized steel water line from the street. To check, look at the pipe where it enters the basement, before the meter. Lead is dull grey and soft: a coin scratches it shiny, and a magnet will not stick to it.
Ontario's drinking water standard for lead is a maximum of 0.010 milligrams per litre, under Ontario Regulation 169/03. The City of Guelph offers a lead test of the tap water in homes built before the mid-1950s, replaces any lead pipe between the water main and the property line at no cost, and offers homeowners a grant toward replacing the lead pipe on their own side, as well as a rebate on qualified water filters. Contact the City about the test and its programme.
The pipe from the property line into the house is the owner's. We replace that section, and it is worth planning the work around the City's timing on its side so the street connection is opened once. Read more on who is allowed to do plumbing work before anyone starts on it.
Why is the water pressure weak upstairs?
Start with one fixture. If only one tap is slow, unscrew the aerator at the spout and look inside. Guelph's tap water comes from the ground and is hard, with a lot of dissolved calcium and magnesium, and that mineral builds up in aerators, shower heads and faucet cartridges. Cleaning or replacing the part often brings the flow back.
If every tap is weak, and worse when two run at once, the pipe is the more likely cause. Galvanized steel rusts from the inside, and over decades the bore closes up until little water gets through. That is common in the pre-1900s houses of the heritage districts. The post-war bungalows and storey-and-a-half houses around Speedvale, Willow West and Stone Road usually have copper water lines, so low pressure there points more often to a partly closed valve, a failing pressure regulator or a scaled fixture. Cleaning a galvanized line only opens it for a short while; replacing the worst runs is the lasting fix.
Is a toilet running, a tap dripping or an outdoor tap split?
A toilet that refills by itself every few minutes is losing water through the flapper or a worn fill valve. Put a few drops of food colouring in the tank and wait without flushing: colour in the bowl means the flapper. A toilet that rocks, or leaves water around its base, has a failed seal at the floor. Stop using it until it is reset, because that water goes into the subfloor and the ceiling below.
A dripping faucet usually needs a cartridge or washer. Hard water wears these faster, which is why the same tap can start dripping again after a few years. The City notes that softeners and conditioners change the effects of hard water, and we can talk through that if fixtures keep scaling.
Outdoor tap damage usually shows up in spring but starts in autumn. Shut the inside valve to the tap before the cold, open the tap outside to drain it, and leave it open. If you turn it on in spring and water appears inside the basement wall, the line froze over winter. Where a house has a history of frozen pipes, the City asks owners to run a small amount of water through the winter months.
Will a repair last, or is it time to replace the pipe?
Before quoting, we look at the pipe on either side of the fault as well as the spot that leaked. A joint that failed on otherwise sound copper is a repair. A pinhole in galvanized steel that is already rusted through elsewhere, or a lead line that tests above the standard, is a replacement, and we explain why and show you the pipe. You choose between the two with both prices in writing.
How does a repair visit go?
The plumber asks what you have seen and since when, confirms the main valve works, and finds the fault. You get the price written down and approve it before any part is fitted. Work is performed by licensed plumbers (306A Certificate of Qualification).
Small repairs to an existing fixture or fitting are usually straightforward. New plumbing, and material changes or repairs to plumbing and drains, generally need a building permit from the City's chief building official, and the City's building department decides whether a given job does. If we think yours will, we say so before the work is booked. For anything below the floor or out to the street, see sewer repair and backwater valves, and for a blocked line, drain cleaning.
