Skip to content
Guelph Plumbing Co

Sump pumps in Guelph

Sump pump repair and installation in Guelph

If the sump pit is filling faster than the pump can empty it, keep away from the outlet and any water on the floor first. Then look for the cause. Guelph Plumbing Co repairs and replaces sump pumps, adds battery backup for power cuts and moves discharge out of the sewer so it drains outside.

For the pit that fills in the spring thaw and the storm that takes the power out.

The pit is filling and the pump is not running: what is safe to do?

If water is at the rim of the pit or on the floor around it, stay away from the pump's cord and the outlet it plugs into. Do not stand in water to unplug anything. If you can reach the electrical panel from a dry floor, switch off the breaker for that part of the basement. If you can't, leave it alone and call. Then move boxes, rugs and anything electrical off the floor nearby.

If the floor is dry and the water in the pit is only rising, there are a few safe checks. Make sure the pump is plugged in, and check whether a breaker or the reset button on the outlet has tripped. If it still won't start, unplug it before you reach into the pit. The float is often caught against the side of the pit, and freeing it can be enough. Plug the pump back in with dry hands and watch it start.

If the pump hums but moves no water, or the pit keeps rising after these checks, call for an emergency plumber. If the basement floor drain is also showing water, stop using water in the house. In many older Guelph houses that drain runs straight to the sewer, not to the pit, so the problem may be a sewer backup rather than a sump problem.

What are the signs a sump pump is wearing out?

A pump that runs and runs when it has not rained usually has a float stuck in the on position or a failed check valve. A bad check valve lets the water in the discharge pipe fall back into the pit, so the pump keeps lifting the same water. A pump that switches on and off every few seconds often has the same fault, or a float set too low.

Humming with no water moving usually means gravel or silt has jammed the impeller, or the motor is failing. Grinding or rattling, rust on the housing and a sour smell from the pit are other signs the pump has been working too hard for too long. The surest sign is a wet pit in heavy rain and a pump that stays silent.

In winter, look at where the discharge pipe comes out outside. If the end is frozen or buried under snow, the pump can run normally and still have nowhere to send the water.

Why does the pit fill fastest in spring?

The City of Guelph says most sewer backups come from a plugged line, but unusually heavy rain also causes them, especially in spring when water from melting snow is building up too. The ground around your foundation gets that same water. Snowmelt and rain soak in together, the weeping tile carries the water to the pit, and a pump that sat idle all winter suddenly has to run hard. That is usually when a worn float switch or a seized impeller shows up.

You can test the pump yourself before the thaw. Pour a pail of water slowly into the pit and watch: the float should rise, the pump should start, and the water level should drop before the pump shuts off. If it doesn't, you have found the problem while the ground is still frozen and the pit is still dry.

Where is a sump pump allowed to drain?

Outside, onto your own property and away from the foundation. It should not drain into the sanitary sewer, which is built for what leaves your sinks and toilets, not for groundwater. Nearby, the Township of Guelph/Eramosa says illegally connected sump pumps and downpipes make Rockwood's sewers overflow when it rains. There is more on that in our page on Rockwood.

How this affects you depends on when your house was built. Houses from the 1950s to the 1970s, around Speedvale, Willow West and Stone Road, often had their weeping tile tied into the sewer when they were built, and that foundation water can overload the sewer in heavy rain. The older houses of Exhibition Park and The Ward often have no weeping tile at all. Their basement floor drain runs straight to the sewer, so in a storm the risk is water coming up through that drain, and the part to ask about is a backwater valve.

In Guelph you own the drain all the way to the main under the street, so it is worth knowing where your foundation water goes. Disconnecting weeping tile from the sewer and sending it to a new sump pit changes the drains. That generally needs a building permit, and the City's building department will tell you whether your job does.

What does a battery backup do in a power cut?

The storms that fill the pit are often the same ones that knock out the power. A battery backup is a second pump in the same pit. It runs from a battery that stays charged while the power is on, and it has its own float. If the main pump stops, from a power cut or a failed motor, the backup starts on its own.

How long it runs depends on the size of the battery and how fast the pit is filling. It is made to get you through an outage, not to replace the main pump for days. Most units have an alarm that sounds when the backup takes over or the battery runs low. Batteries wear out, so check the manufacturer's replacement interval and warranty terms, and write the install date on the battery.

How is a sump pump repaired or replaced?

The plumber starts at the pit and checks how fast it fills, the size and depth of the pump, the float, the check valve and where the discharge pipe ends up outside. Sometimes the repair is a new float switch or check valve. Sometimes the pump is worn out or too small for the water coming in, and replacing it makes more sense. You see the written price and approve it before any part goes in.

Work is performed by licensed plumbers (306A Certificate of Qualification). A replacement usually includes the pump, a new check valve and the discharge connection, plus a backup pump and alarm if you want them. If the pump has been draining into the sewer, the discharge can be rerouted outside at the same time.

Keep the paperwork that comes with the new pump. The pump's own warranty is with the manufacturer, and you may need to show when it was installed.

What you can count on

What can you expect from Guelph Plumbing Co?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about sump pumps

How much does it cost to replace a sump pump motor?

On most household sump pumps, the motor is sealed inside the pump, so when it fails the whole pump is usually replaced. The price depends on the pump, the pit and whether the discharge pipe or check valve also needs work, and Guelph Plumbing Co writes it down before starting. Before you replace anything, check that the float moves freely. Also check that the water goes outside the house, not into a laundry tub or the sanitary drain. The pump matters most during spring thaw and heavy rain. See sump pumps.

All questions

Ready for a written price?

If water is still moving, shut the main valve first, then tell us what happened. The plumber explains the likely cause, and the price is written down before work starts.