Skip to content
Guelph Plumbing Co

Sewers and backwater valves

Sewer repair and backwater valves in Guelph

When the basement floor drain backs up, stop using water and stay clear of anything electrical near it. Guelph Plumbing Co inspects sewer lines by camera, repairs or replaces clay and fibre laterals, and installs backwater valves, with a written price first. Sewage on the floor now? Call an emergency plumber.

Find where the sewer has failed, repair that part and keep the street's water out of the basement.

Is sewage coming up through the floor drain right now?

Stop using water first. Don't flush, run the washer or dishwasher, or take a shower. Water you send down any drain upstairs comes out at the lowest opening, and in most houses that is the basement floor drain. If the water is near the furnace, a power bar or an outlet, stay out of it. If you can reach the electrical panel without standing in water, switch off the breaker for that area. If you can't, leave it alone. Don't pour chemical drain cleaner into a backed-up line, because it stays in the water that someone will have to work in.

Then look outside if you can. If neighbours on the street have the same problem, the blockage may be in the main sewer under the road. Only City crews are allowed to clear that, so report it to the City as well. If it is only your house, the blockage is more likely in your own drain between the house and the street. Call for an emergency plumber and take photos for your insurer. The sewer backup guide explains cleanup step by step.

Why does the floor drain back up in Guelph's older houses?

Many houses in St. George's Park, Exhibition Park, The Ward and the Brooklyn and College Hill district were built between the 1850s and the early 1900s. Ontario houses of that age usually had a clay sewer pipe to the street and a basement floor drain connected straight to it, with no weeping tile. When that line slows down, because of roots in a cracked clay joint or a blockage further along, the water comes up through the floor drain.

The post-war streets near Speedvale, Willow West, Stone Road and south of College Avenue tend to have different problems. Houses from the 1950s to the 1970s often have a sewer pipe made of clay or bituminous fibre, and fibre pipe tends to lose its round shape or collapse as it ages. The weeping tile was often connected to the sewer, so in a heavy storm the water draining from around the foundation goes into the same line. The City of Guelph says most backups are caused by a plugged line, but unusually heavy rain causes them too, especially in spring when melting snow adds more water. That is why a drain that works all year can back up in a March downpour.

What are the signs the sewer pipe itself is failing?

One slow sink is usually just a local clog. These signs point to the main sewer line from the house instead: the floor drain or a basement toilet backs up when the washing machine empties, toilets gurgle when a tub drains, the floor drain smells of sewage, or the same blockage keeps coming back every few months after it has been cleared. If drain cleaning pulls roots out on the cable, they are getting in through a joint or a crack, and they will grow back.

Outside, a soft or sunken strip of lawn along the line from the house to the street can mean a broken pipe is washing soil away. None of these signs tells you exactly what is wrong, but any of them means it is time to look inside the pipe.

Who is responsible for the sewer between your house and the street?

In Guelph the property owner is responsible for the building sewer and the private drain all the way to the main sanitary sewer under the street, not just to the property line. A cracked clay joint under the boulevard or a collapsed fibre section near the road is still the owner's pipe to repair. The main sewer belongs to the City, and only City crews are allowed to clear a blockage in it.

Before you plan a repair, a camera inspection usually shows where the fault is: on your side, at the connection to the main, or in the main itself. If it is in the main, contact the City.

What does a camera inspection show, and what are the repair options?

The camera goes in through a cleanout. If the house has none, it can go through the floor drain, or through the toilet drain with the toilet lifted off. As it moves toward the street, it shows roots at the joints, cracks, joints that have shifted, low spots where water sits, or fibre pipe that has gone flat. A locator above ground picks up the signal from the camera head, so the depth and position of a fault can be marked on the lawn or driveway. If you want to see the pipe yourself, ask to watch the screen.

What comes next depends on what the camera finds. A single broken joint or a short collapsed section can often be dug up and replaced on its own. If a clay or fibre line has faults along much of its length, it is usually better to replace it from the house to the main than to fix it one spot at a time. If the pipe is sound and has only a few roots, regular cleaning may be enough for now. You get a written price for the option you choose and approve it before work starts.

When does a house need a backwater valve, and how is one installed?

A backwater valve is fitted in the building drain. It closes when sewage flows backward from the street, so an overloaded main can't push water up through the floor drain. Ontario's Building Code (Part 7, Article 7.4.6.4.) requires one in new work wherever a drain could take backflow. That means drains from fixtures lower than the street next to the house, or fixtures lower than the cover of the upstream sanitary manhole in a house on a public sewer. Whether your basement fixtures are below those levels has to be measured at the house.

Fitting a valve means breaking up part of the basement floor, cutting the valve into the drain and leaving an access cover so the valve can be checked and cleaned. Changes to drains generally need a building permit, and the City's building department decides whether a particular job does. If the work means digging outside, a locate has to be requested through Ontario Dig Authority first. The request costs nothing, but public locates don't cover private lines such as your own sewer, which is one more reason to run the camera and locator first.

If the weeping tile drains into the sewer, a valve on its own can leave foundation water with nowhere to go when the valve closes. The usual fix is a sump pump that discharges outside. Work is performed by licensed plumbers (306A Certificate of Qualification). For a written price, use the quote form.

What you can count on

What can you expect from Guelph Plumbing Co?

  • Licensed and insured

    Every plumber holds a current 306A Certificate of Qualification and is covered by liability insurance. Your home is protected on every job.

  • Every call is answered

    Day or night, a person or our receptionist answers, takes the details and a plumber calls you back.

  • Written price before work starts

    You see the number and approve it before any part is fitted. No surprises on the invoice.

  • 1-year workmanship warranty

    All labour comes backed by a one-year warranty. If a repair we made fails within the warranty period, we return and fix it at no additional labour cost.

Questions about sewer repair

What does a sewer backup cover?

On home insurance, sewer backup is often a separate add-on to the policy rather than part of the basic cover. The insurer sets the limit, the deductible and any conditions, such as having a backwater valve fitted. Read your policy or ask your broker before you need it. If a backup has already happened, stop using water and stay away from outlets near the water. Photograph everything before you clean, and keep damaged items until the adjuster has seen them. Then read our sewer backup guide.

All questions

Ready for a written price?

If water is still moving, shut the main valve first, then tell us what happened. The plumber explains the likely cause, and the price is written down before work starts.