A pipe has burst or the ceiling is dripping. What do I do first?
Turn off the main water valve. It is usually in the basement where the water line comes through the foundation, close to the meter. Turn it clockwise until it stops. Then open the lowest cold tap in the house, such as a laundry tub or a basement sink, so the water left in the pipes drains out there instead of through the break.
Keep away from water near a light fitting, an outlet or the electrical panel. If you can reach the panel from a dry floor, switch off the breaker for the wet area. If you cannot, stay out of that room and mention it when you call. After that, move what you can off the floor and take photos for your insurer.
A valve that has not been turned in years may be stiff. Firm pressure by hand is fine. Putting a wrench on a corroded valve stem can snap it, and then you have two leaks. If it will not move, leave it alone and tell the plumber when you call.
Sewage is coming up through the floor drain. Is it safe to stay in the basement?
Stop using water anywhere in the house: no flushing, no showers and no washing machine or dishwasher. Whatever goes down a drain upstairs can come out at the lowest opening, which is the floor drain. Stay out of standing sewage, keep children and pets upstairs, and keep away from outlets and appliances on a wet floor.
In the older parts of the city, like St. George's Park, Exhibition Park, The Ward and Brooklyn and College Hill, the basement floor drain often runs straight to a clay sewer pipe. Tree roots get in at the joints of clay pipe and build up into a blockage. In the post-war streets around Speedvale, Willow West and Stone Road, the weeping tile is often tied into the sewer, and the sewer pipe may be clay or bituminous fibre, which can sag out of round over time. The City of Guelph says most sewer backups happen because a line is plugged. Unusually heavy rain causes them too, especially in spring when melting snow is adding water at the same time.
In Guelph, the property owner is responsible for the private drain all the way to the main sewer under the street. Only City crews can clear a blockage in the main itself. A plumber can work out which side of that line the blockage is on. Our sewer backup guide explains this in more detail, and sewer repair and backwater valves covers what to do once the water has gone down.
No water comes out of a tap in winter. Is the pipe frozen, and will it burst?
If one tap gives nothing or only a trickle in a cold snap, and the rest of the house has water, that pipe has probably frozen. It is usually on an outside wall, in a crawl space or close to a garage. Leave the tap open so the water has somewhere to go as the ice melts. Warm the pipe slowly, starting at the tap end, with a hair dryer or a space heater kept well away from anything that can burn. Never use a torch or any open flame on a pipe.
Before you start, check the frozen section for bulges and splits. If you see one, turn off the main valve before warming it. The ice usually keeps a split plugged, so it only starts leaking as the pipe thaws.
The City of Guelph says frost retreats slowly, usually from the top down, so a buried pipe can stay frozen until well after spring has arrived. The City asks homes with a history of frozen pipes to run a small amount of water through the winter. Our frozen pipes guide covers prevention, including lines from a well.
The toilet is overflowing or a leak will not stop. What can I shut off without the main?
For a toilet, turn the small valve on the wall behind it clockwise. If it will not turn, take the lid off the tank and lift the float up to stop the fill. Do not flush again. If more than one toilet or drain is backing up, the blockage is further down, so treat it as a sewer backup and stop using water in the whole house.
Most sinks have their own shut-off valves in the cabinet underneath. Turning those off lets you keep water running to the rest of the house while you wait.
If the water heater is leaking from the base, close the cold-water valve on the pipe going into the top of the tank and switch off the breaker for an electric unit. Leave the gas controls alone. Gas work is performed by TSSA-certified gas technicians. More on tanks is on our water heaters page.
What happens once the plumber arrives?
The plumber first confirms the water is stopped, then finds the source, which might be a split pipe, a failed fitting, a blocked drain or a tank that has given out. For a backup, that can mean clearing the line from a cleanout and running a camera down the sewer to see whether roots, a collapse or something in the City's main caused it. You see a written price and approve it before any repair begins. Work is performed by licensed plumbers (306A Certificate of Qualification).
Sometimes the first visit is only enough to make things safe, for example by capping a burst line. If so, the plumber explains what the permanent repair involves. Changes to drains generally need a building permit, and the City's building department decides whether a particular job does. If the yard has to be dug up, a locate must be requested through Ontario Dig Authority first. Public locates do not mark your own sewer line. For smaller jobs that can wait, see plumbing repairs and drain cleaning.
